Rhino Spray For Fiberglass Boats: Does It Work?

Rhino lining is a spray that can be used on boats. Some people have used it on the bottom of their boats, but others have warned that it will create more drag and slow the boat down. Rhino lining can be used over fibreglass, but not in place of fibreglass.

Rhino lining vs carpet

Rhino lining is a spray that can be used to coat the floor of a boat. It is waterproof and wear-resistant. However, it is not suitable as a replacement for fibreglass and can create more drag. It is also more expensive than carpet, costing around $10/foot plus prep.

Carpet is a cheaper option for boat flooring, but it may not be as durable as rhino lining. It can be stripped and replaced with rhino lining if desired.

Some people choose to use rhino lining over carpet because it is more durable and can be sprayed on, creating a seamless finish. However, others prefer Line-x over Rhino lining as it is cheaper.

Ultimately, the decision between rhino lining and carpet comes down to personal preference and budget. Both options have their advantages and disadvantages, and the key to a good job is proper preparation.

Rhino lining vs Line-x

Rhino spray can be used on a fibreglass boat bottom, but it is not recommended as a replacement for fibreglass. Rhino lining is more rubbery and grippy, whereas Line-x is more like coarse sandpaper or hard plastic. Line-x is more durable and offers a higher hardness level than Rhino, which may be preferable for those carrying large or sharp metal tools. However, Rhino's SolarMax, Extreme, and HardLine formulas have a similar level of hardness to Line-x liners. Rhino is also easier on exposed skin and is less likely to cause chipping. Line-x is more expensive at $10/foot plus prep, whereas Rhino costs $900-$1100 for an 18.5-foot deep hull. It is important to note that both products require proper preparation for a good job.

Rhino lining vs gel coat

Rhino Linings is a protective coating that can be applied to a wide variety of surfaces, including metal, concrete, and wood. It offers superior durability and resistance to corrosion, extreme temperatures, and UV rays. It is also highly customizable, allowing for the addition of various additives to meet specific application requirements.

Rhino Linings can be applied to the bottom of a boat, but it is not recommended as a replacement for fibreglass. Some people have tried using Rhino Linings over fibreglass with mixed results. One user reported that it will separate from the decking, while another said that it created more drag.

A better alternative to Rhino Linings for boat bottoms is Line-X. Line-X is applied using high pressure and high heat, which increases adhesion onto gelcoat. The heat expands the substrate, allowing the Line-X to flow into the surface and then dry, becoming almost part of the gelcoat. Line-X is also more cost-effective, with a cost of about $10/foot plus prep, compared to Rhino Linings, which can cost $900-$1100 for an 18.5-foot deep hull.

However, it is important to note that prep is key to a good job, regardless of the product chosen. Proper preparation will ensure that the coating adheres properly and lasts longer.

Rhino lining on the bottom of a boat

Rhino lining is a popular alternative to fibreglass for boat decks. It is waterproof and wear-resistant, but it is not recommended to use it to replace fibreglass. Instead, it is often used over fibreglass to encapsulate the decking with poly or epoxy.

Some people have tried using rhino liner on the bottom of their boats, but it is not recommended as it will create more drag and slow the boat down. If you are looking for an alternative to carpet, there are other options available such as Line-x, which is a more rubbery coating that can be sprayed or painted on.

Prep is key to a good job, no matter which product you choose. Make sure to strip the carpet, prep the surface, and spray or roll on the coating. This process can take about a week and cost around $900-$1100, depending on the size of your boat.

Rhino lining on the floor of a boat

Rhino lining can be used on the floor of a boat, but it is not recommended as a replacement for fibreglass. Instead, it is often used over fibreglass. Rhino lining is waterproof and wear-resistant, but it will create more drag and slow the boat down. It is also important to note that rhino lining will separate from the decking over time, so it is not a long-lasting solution. To ensure a good job, proper preparation is key.

Frequently asked questions